Jan C. Still Lugerforums banner
1 - 12 of 12 Posts

· Registered
Joined
·
109 Posts
By the 20,000 range they were using assembly numbers rather than serial numbers. Look for a small kana symbol (maybe this one:
Font Symbol Rectangle Brand Logo
)

on the left side of the frame under the grip, above a 3 digit number. That’s the assembly number. See if that matches the grip number.
 
  • Like
Reactions: Gunstorian

· Registered
Joined
·
2,025 Posts
Nice Type 26 Hood. I still am not able to tell if a 26 was arsenal refinished or not but learned a new tip from Mauser. I will have to look at mine. The trigger and the hammer may have both been fire blued from the factory.
John
 

· Registered
Joined
·
3,503 Posts
Most Type 26 revolvers went through an arsenal at least once, given the long service life. I would estimate that only 20-30% remain in the original condition: with fireblued hammer, trigger and the barrel swivel pin in addition to “carbonia” blue on the rest of the gun(very similar to colt and S&W blue of that era). Of those, a tiny percentage can be found in excellent condition. In fact, an original 95% or better finish Type 26 is one of the most difficult to obtain military revolvers.
 

· Registered
Joined
·
107 Posts
Very nice! I am still missing one from my Japanese firearm collection, and for me; yours would definitely be a contender!

I have to say, though, I cringe whenever I see any type of metal collectible photographed on the ground - especially a concrete or stone finish - just me, but, I'd at least put down a towel or something soft...yikes!

KK
 
1 - 12 of 12 Posts
Top