Jan C. Still Lugerforums banner
1 - 5 of 5 Posts

·
Registered
Joined
·
3 Posts
Discussion Starter · #1 ·
Hello, I recently purchased a Walther mod hp swedish contract (second contract). The hammer release was broken off, and only the lower part with the hole was still attached with the hammer pin. I'm in search of finding the correct hammer release. The ones they have at numerich and cdnn won't work as they are the later design. If anyone has an extra one laying in a drawer and would sell it, I would be very grateful. Or even point me in the right direction of who may have one. Thanks
 

·
Super Moderator
Joined
·
2,789 Posts
Find a good machine shop and have one made (if worse comes to worse). You can heat treat it yourself. Heat it until it's cherry red and then drop it in some oil to quinch it. It probably will look as dark-colored as an original.
 

·
Registered
Joined
·
3 Posts
Discussion Starter · #4 ·
That's plan B, but I would need an original to get dimensions from but the easiest and most mistake free way would be to get someone to make carbon copy of theirs and mail it to me.
 
1 - 5 of 5 Posts
Top